Terminals - ABB CBXi Series User Manual

TERMINALS

©ABB 2022 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
Terminal
Numbers
93, 94 24 V AC Power
13 ... 15 Auxiliary Power: 18 V DC output on 2 terminals, 60 mA total
95, 96 RS-485 Port 1 (BACnet® MS/TP) screw terminal
MS/TP subnet terminator switch is located beside the port. If the
switch is towards the icon, then termination is
towards the icon then termination is
39 ... 42 CBT-STAT / RS-485 Port 2 (CBT-STAT / Modbus)
The bus Terminator Switch is located beside the port. If the switch is
towards the icon, then termination is
the icon then termination is
Universal Inputs
1 ... 12
When input is configured as Digital:
• LED Off: open circuit or logic 'off'
• LED On: logic 'on'
When input is configured as Resistor/thermistor:
• LED Off: valid resistance connected (Note: 0 Ω is counted as valid)
• LED Slow blink: resistor/thermistor not connected
When input is configured as Analog:
• LED intensity is modulated by the analog signal
When the LED is blinking:
• Fast blink indicates error condition
• Two short flashes followed by a value* indicates the input is in an
override state (overridden by
*Note: The LED intensity illustrates the value measured at the input
terminals. The flash indicates that this value has been overridden.
25 ... 38 UniPuts™ + Relay
When a Uniput channel is configured as an input, the LED signals are
identical to Universal Inputs above. When configured as an output the
following apply:
When output is configured as Digital:
• LED Off: open circuit or logic 'off'
• LED On: logic 'on'
When output is configured as Analog:
• LED intensity is modulated by the analog signal
When the LED is blinking:
• Fast blink indicates error condition
• Two short flashes followed by a value indicates the output is in an
override state (overridden by
CBXi IP Controller |
Description
.
out
and if the switch is towards
in
.
out
).
CXpro HD
or HOA).
CXpro HD
CBXi Operation
and if the switch is
in
64