Removing Stubborn Soiling (Excluding The Flexiclip Runners); Stubborn Soiling On The Flexiclip Runners - Miele DGC 735 Series Operating And Installation Instructions

Removing stubborn soiling
(excluding the FlexiClip runners)
Spilt fruit and roasting juices may
cause lasting discolouration or matt
patches on surfaces. This
discolouration will not affect the
properties of the surface finish.
Do not attempt to remove these stains.
Only use the equipment specified.
 Baked-on deposits can be removed
with a glass scraper or with a
stainless-steel spiral pad (e.g.
Spontex Spirinett), hot water and
washing-up liquid.
Tip: It is easier to clean the appliance if
you use the Further
Soak programme (see "Care").
Exposure to scouring agents,
abrasive brushes or sponges and
oven cleaner can cause catalytic
enamel to lose its self-cleaning
properties.
Remove the catalytic enamelled
panels before using an oven cleaner.
Using oven cleaners
 Very stubborn soiling on PerfectClean
surfaces can be cleaned using the
Miele oven cleaner, which must only
be applied to cold surfaces.
If the oven spray gets into gaps and
openings, a strong odour is
generated during subsequent
cooking programmes.
Do not spray the oven cleaner onto
the roof of the oven compartment.
Do not spray the oven cleaner into
the gaps and openings of the oven
compartment walls and rear wall.
 | Maintenance
 Follow the instructions on the
packaging.
Oven cleaners from other
manufacturers must only be used in a
cold oven and for no longer than a
maximum of 10 minutes.
 You can then also use the scouring
pad on the back of a washing-up
sponge to remove the soiling.
 Remove all cleaning agent residues
thoroughly with clean water.
 Dry all surfaces with a soft cloth.
Stubborn soiling on the
FlexiClip runners
|
Cleaning FlexiClip telescopic runners
in a dishwasher would remove the
special grease which is essential for
their smooth functioning.
Never attempt to clean FlexiClip
telescopic runners in a dishwasher.
For stubborn surface soiling or if the
bearings become sticky with spilled fruit
juices proceed as follows:
 Soak the FlexiClip runners for approx.
10 minutes in a solution of hot water
and washing-up liquid.
If necessary use the back of a
washing-up sponge to remove the
soiling. The bearings can be carefully
cleaned with a soft brush.
Cleaning may cause some
discolouration or fading in places,
however this will not affect the
functioning of the runners in any way.
Cleaning and care
87