Replacing The Main Tray Assembly - HP C160 Owner's Manual

Changing Your Workstation's Hardware Configuration

Replacing the Main Tray Assembly

Replacing the Main Tray Assembly
Perform the following steps to replace the main tray assembly:
1 Align the main tray assembly with the chassis and slide it into place, as shown in
Figure 39
2 Slide the main tray in until you feel it make contact with the internal connectors.
3 Push firmly and evenly on the main tray assembly to make sure that all connec-
4 Start all five thumb screws loosely, then tighten them firmly. See Figure 39.
NOTICE: To maintain FCC/EMI compliance, verify that the main tray is fully seated
and all four thumb screws are completely tightened.
124
Figure 39.
Thumb Screws
Replacing the Main Tray Assembly
tors are fully seated.
Thumb
Screws