Installing A Hard Disk Drive In Position 1 - HP C160 Owner's Manual

Installing a Hard Disk Drive in Position 1

Perform the following procedure to install a hard disk drive:
1 Remove the disk filler panel from the bottom location of the bezel by using a coin
Figure 32
2 Reach into the storage bay and locate the power and data cables for the disk drive.
3 Connect the cables to the drive.
4 From the front of the storage tray, line up the disk slides on the hard disk drive
or other flat, blunt object to pry it from the front, as shown in Figure 32.
Removing a Disk Filler Panel
Refer to the cable routing label on the storage tray. See Figure 33.
with the position 1 slots in the storage tray chassis and slide it into place, as shown
in Figure 33.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
113