Advertisement
Toilets
– Valves must be full-bore valves of marine sanitation quality. Do not use screw-to-close
gate valves.
– Flexible hoses must be of marine sanitation quality and must be secured to any fittings
with two stainless steel, worm-drive, hose-band clamps at each connection. Check
connections frequently for integrity.
– Use properly positioned, ventilated loops when the potential exists for the toilet rim to
fall below the waterline during any heel, load, or trim condition, or when the toilet is
connected to any through-the hull fittings. The ventilated loops must be installed in the
intake (if connected to raw water) and/or the discharge piping.
– Ensure that all electrical power to the toilet is turned off and that seacocks are in the
closed or off position before installing the toilet or performing any maintenance.
– If the toilet uses fresh water for flushing and is connected directly or indirectly to a
shore side municipal water system at any time: shoreside water connections must be
disconnected if the boat is unattended (even if boat is unattended for a brief period).
– If the toilet is connected to any through-the-hull fittings: all flexible hoses must be of
marine sanitation quality and must be secured to any fittings (such as those at seacock,
vented loop, or toilet) with two stainless steel worm-drive hose band clamps at each
connection. Connections must be checked frequently for integrity.
–
If the toilet uses raw water for flushing at any time, a raw-water pump controlled by an
automatically operat ing demand switch must not be installed. If the onboard water
valve or any plumbing connections were to leak, the automatically operated pump
would start and could flood the boat.
RISK OF PROPERTY DAMAGE: Failure to obey the following notices may cause
damage to the toilet or toilet system.
•
Only flush water, bodily wastes, and rapid-dissolving toilet tissue.
•
Do not overfill the holding tank, or serious damage can occur to the sanitation system.
Overfilling the holding tank can rupture the holding tank or release tank contents into the
bilge.
•
This toilet system is not intended for raw water flush toilet systems and is not designed to
flush with seawater. Only use a fresh water supply.
2
GENERAL INFORMATION
Included Parts
RushFlush toilet
Check valve
Flush switch and status panel (9400 and 9500 only)
Optional Parts*
System status panel (9300 only)
*Available as accessory (not included)
EN
High-flow electric water valve
Maintenance valve
4
Advertisement
