Advertisement
Toilets
24
Toilet
(Rear)
Wiring
➤ Connect the discharge plumbing
from the holding tank to the discharge
flange or waste outlet. See section "5.1
Understanding requirements for the fresh-
water system" on page 9.
➤ Position the toilet near the discharge flange.
➤ Connect the upper rim water supply line
to the water valve.
➤ Route the wiring for the control module
through the wiring access hole and up
through the toilet plumbing lines.
➤ Connect the lower bowl water supply line
to the toilet, looping the line as shown.
–
For through-the-wall installations, loop
through the elbow fitting down to the
inlet at the toilet base.
26
Cover
Bolt
I
Do not slide the toilet over the
discharge flange. Carefully align and
place over the adapter to prevent
possible damage.
➤ Adjust the toilet so the toilet mounting
bolt holes are aligned with the pilot holes
and the discharge adapter is aligned with
the sealing grommet in the floor flange.
Press straight down to secure.
➤ "Test the toilet for leaks" before proceeding.
➤ Secure the toilet to the floor, using #14
x 2-1/2" lag bolts. Push the decorative
covers onto the bolt heads.
EN
25
Lower
Bowl Water
Supply Line
Upper
Rim Water
Supply Line
➤ Remove the control module from the
inside and back of the toilet.
➤ Attach the panel cable to the toilet control
module (RJ45 connector).
➤ Reattach the control module to the back
of the toilet.
➤ Set the toilet back in place by inserting
the discharge outlet into the sealing
grommet.
Test the toilet for leaks
➤ Turn on the water supply and electrical
power to the toilet.
➤ Lift the flush handle, or push "add water"
button for several seconds.
➤ Flush the toilet multiple times to observe
operation. To adjust flush duration,
see section "6.4 Adjusting the water
consumption settings" on page 17.
➤ Wait one hour and check for leaks on the
floor and at the rear of the toilet.
Control
Toilet
Module
(Rear)
Switch
Connector
Sealing
Grommet
16
Advertisement
