Instructions; Intended Use; General Information - Dometic M65-700 Instruction And Operation Manual

Gravity-discharge Toilet
• If the toilet is connected to any thru-hull fittings, all flexible
hoses must be of marine sanitation quality and must be
secured to any fittings (such as those at the seacock or
toilet) with two stainless steel, worm-drive hose band
clamps at each connection. Connections must be
checked frequently for integrity.
• Ensure that seacocks are in the closed or off position
before installing the toilet or performing any maintenance.
• If the toilet uses fresh water for flushing and is connected
directly or indirectly to a shoreside municipal water
system at any time, shoreside water connections must
be disconnected if the boat is unattended (even if boat is
unattended for a brief period).
• Use only Dometic replacement parts and components that
are specifically approved for use with the appliance.
• Avoid improper installation, adjustment, alterations,
service, or maintenance of the appliance. Service and
maintenance must be done by a qualified service person
only.
• Do not modify this product in any way. Modification can
be extremely hazardous.
NOTICE: Do not overfill the holding tank, or damage can
occur to the sanitation system.

2 Intended Use

The Gravity-discharge Toilet (hereinafter referred to as
toilet) is designed and intended for installation in a boat
during or after manufacture. This toilet is only suitable for the
intended purpose and application in accordance with these

instructions.

This manual provides information that is necessary for proper
installation and operation of the toilet. Poor installation and/or
improper operating or maintenance will result in unsatisfactory
performance and a possible failure. The manufacturer accepts
no liability for any injury or damage to the product resulting
from:
• Incorrect assembly or connection, including excess
voltage
• Incorrect maintenance or use of spare parts other than
original spare parts provided by the manufacturer
• Alterations to the product without express permission from
the manufacturer
• Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and
product specifications.
EN

3 General Information

This section provides general information about the toilet and
its components and dimensions.
I
The images used in this document are for reference
purposes only. Components and component locations
may vary according to specific product models.
Measurements may vary ±0.38 in. (10 mm).
3 .1 Tools and Materials
Dometic recommends that the following tools and materials
be used while installing the appliance.
Included Parts
Gravity-discharge Toilet
Tank Mounting Screws with Washers (4)
Installer-Supplied Parts
Thru-hull Vent Fitting
Dockside Discharge Fitting
5/8 in. (16 mm) I.D. Marine Sanitation Quality Hose
1.5 in. (38 mm) I.D. Marine Sanitation Quality Hose
Stainless Steel Band Clamps (8)
Water Supply
Recommended Tools
Drill Pan-head Screwdriver
Drill Bit Screwdriver for Band Clamps
Marker Phillips-head Screwdriver
3 .2 Model Identification
The model identification label is located on the front of the
base of the toilet under the pedestal cover. See "Component
Locations" on page 4.
SO 1234
Model :
123456789
Item :
123456789
Serial :
1 Model Identification Label
Intended Use
123456789
PNC :
3