Log Files - Nortel 3050 Troubleshooting Manual

10 Troubleshooting Fundamentals
Table 2
Interpreting SSL acceleration log files
Message
Failed to initialize SSL
hardware
Set CSWIFT as default
ssl-hw-fail
Using <hardware
type> hardware

Log files

View the log files to see the history of system events.
This troubleshooting guide documents only the most common messages
from the ssl.log.
/maint/debug/proxydebug [on|off|once]
on: enable simpleproxy to print out debug message.
off: disable simpleproxy to print out debug message.
once: enable simpleproxy to print out debug message only once.
ATTENTION
Enabling proxydebug will use more CPU resource. Make sure to disable it after
you finish debugging.
Transmit the event log from the Nortel VPN Gateway to a file on a TFTP,
FTP, or SFTP server. Specify the IP address or host name of the server
as well as the file name. The default value is TFTP.
Table 3 "Log file types in a log dump" (page 11)
a log dump.
Copyright © 2007 Nortel Networks
.
Severity
ERROR
INFO
ALARM (MAJOR)
INFO
Nortel VPN Gateway
Troubleshooting Guide
NN46120-700 01.01 Standard
12 October 2007
Type
Traffic processing
Startup
System control
Startup
lists the log file types in
Description
The SSL acceleration
hardware failed to
initialize and the NVG
runs with degraded
performance.
The NVG is using
CSWIFT SSL
hardware acceleration.
The SSL hardware
acceleration card
could not be found or
initiated and the NVG
runs with degraded
performance.
The NVG is using
<hardware type>
hardware for SSL
acceleration.