Frequently Used Series Telephone Codes; Radio Triggers - Tunstall Lifeline Vi Installation And Programming Manual

D5707018A Installation and Programming Guide V2.4

Frequently used series telephone codes

Enter programming mode as described on the previous page, lift the telephone
handset and then enter the following codes:
Resetting the home unit but retaining radio triggers
To reset all previous programmed information except the radio triggers, press:
This code means all functions are reset to default settings. The date and time remain
unchanged.
Resetting the home unit
To reset all previous programmed information press:
Resetting erases all programmed telecare sensors and triggers and all functions are
reset to default settings. The date and time remain unchanged.
Setting the time and date
There is a real time 24 hour clock in the home unit which automatically adjusts to
BST. During power cuts the clock is backed up by the home unit's battery for up to 40
hours. However if the unit is powered down for transit then the clock must be reset
again when the home unit is installed in the user's home. Once the time has been set
the time can be checked by using the quick code 3020 (Lifeline Vi+ only). The unit
will then announce the date and time. During the first 30 minutes of installation the
Lifeline Vi+ will also announce the date and time when an incoming telephone call is
received (requires CLI on the telephone line). To set the clock press:
DDMMYY HH MM X Y
DD represents the day of the month (01-31)
MM represents the months (01-12)
YY represents the two digit year (00-99)
HH represents hours 00-23; 24 cannot be programmed
MM represents minutes 00-59; 60 cannot be programmed
X represents the daylight saving time zone (0 = disabled, 1 = Europe, 2 = US)
Y represents enable/disable auto CLI time update feature (0 = disable, 1 = enable)
Page 19 of 68