Tunstall Lifeline Vi Installation And Programming Manual page 20

D5707018A
Telephone numbers
The series telephone keypad supports the programming of 10 alarm numbers. By
default, telephone numbers 1-4 are set to call control centres (CC) and telephone
numbers 5-10 are set to a Personal Recipient (PR) destination. To change the
destination from CC to PR or normal telephone (POTS) see the next section.
Control centre numbers
Control centre numbers are programmed by pressing:
Sets telephone number 1
To set tel. number 2 replace 00 with 01
To set tel. number 3 replace 00 with 07
To set tel. number 4 replace 00 with 08
To set tel. number 5 replace 00 with 09
To set tel. number 6 replace 00 with 10
NOTE: A pause can be entered when programming alarm numbers by pressing
telephone number.
Changing telephone number destination to PR or POTS
To program an existing telephone number to a PR or POTS destination, press:
XY
Where X represents the telephone number position (1-9 with 0 = 10)
Where Y represents the destination type CC (0), PR (1) and POTS (2)
NOTE: It is important to set the correct destination type otherwise the recipient of the alarm call will not
be able to deal with it correctly. A CC call expects a particular handshake from the control centre, a PR
call requires a recipient with a touch tone telephone and a POTS call is a normal telephone call (i.e. fast
dial button).
Installation and Programming Guide V2.4
Tel. No. (max 20 digits)
To set tel. number 7 replace 00 with 39
To set tel. number 8 replace 00 with 40
To set tel. number 9 replace 00 with 41
To set tel. number 10 replace 00 with 42
Page 20 of 68
#2
as part of the