3.3
Separating Control Panel from Controller
3.3.1
Removing Control Panel
Remove the control panel in the following manner.
a)
Loosen the four (4) screws at the four (4) corners, which secure the control panel.
b)
Remove these screws, then carefully draw out the control panel toward your side.
(Be careful of the cable connected on the rear side.)
Control panel
TRANSPORTATION & INSTALLATION MANUAL
Controller
Fig. 3.4 Removing control panel
– 3–9 –
警 告
感 電 に よ り 死 傷 の 恐 れ が あ
り ま す 。
保 守 ・ 点 検 作 業 の 前 に 必 ず
電 源 を 切 り 、 コ ン ト ロ - ラ
の 電 源 コ ネ ク タ (AC IN )を
は ず し て く だ さ い 。
注 意
コ ネ ク タ (AC I N)の 電 源 線 と ア - ス 線 の
接 続 は 必 ず 下 図 の 配 線 に し て く だ さ い 。
誤 配 線 す る と 、 感 電 や 機 器 破 損 の 原 因 と
な り ま す 。
<コントロ ーラ側 >
AC IN
2 φ
AC180 ~ 250 V
50/60 Hz
STE 80897