1.3
Storage
Both the robot and controller should not be stored for a long period of time after
unpacked. When this is unavoidable, however, be sure to observe the following
cautions on storage.
1.3.1
Cautions on Robot Storage
•
Secure the robot base completely to prevent the robot from falling over.
•
Keep the robot out of direct sunlight. Otherwise, the parts may deteriorate.
•
Seal the robot in a vinyl bag to prevent rust development and contaminant.
Put a desiccant in the bag to absorb moisture.
•
When the robot motor drive cable was disconnected from the controller,
connect the short-circuit connector to the same cable.
1.3.2
Cautions on Robot Controller Storage
•
Keep the robot controller out of direct sunlight. Otherwise, the controller
interior will be heated up, resulting in faults.
TRANSPORTATION & INSTALLATION MANUAL
!
CAUTION
!
CAUTION
– 1–5 –
STE 80897