Table of Contents
Advertisement
Installation manual
00825-0100-3812
3.7.2
Base enclosure security seals
Use the following instructions to install the security seal wire on the Base
Enclosure.
Procedure
1. Install security wire seal into and through two of the four the holes in the
2. Position the wire to prevent counterclockwise rotation of the screws when
3. Twist and adjust wire removing all slack and seal.
4. Cut wire ends to remove excess wire.
3.7.3
Seal the Junction Box remote mount electronics
option
Use the following instructions to install the security seal wire on the junction box,
if required.
Installation manual
socket head screws on the Base Enclosure cover (maximum wire diameter
0.078 inch; 2.0 mm).
Figure 3-10: Base Enclosure security seals
A. Base Enclosure
B. Security wire seals
the seal wire is taut.
This completes Base Enclosure security seal installation procedure.
Electrical Installation
January 2023
61
Advertisement
Table of Contents
