AUMA SQEx 05.2 Manual page 45

Ref. no. Designation
005.0 Drive shaft
005.1 Motor coupling
005.3 Manual drive coupling
009.0 Manual gearing
019.0 Crown wheel
023.0 Output drive wheel for limit switches
024.0 Drive wheel for limit switches
025.0 Locking plate
058.0 Cable for protective earth
070.0 Motor (incl. ref. no. 079.0)
079.0 Planetary gearing for motor drive
155.0 Reduction gearing
500.0 Cover
502.0 Pin carrier without pins
505.0 Pin for controls
506.0 Pin for motor
525.0 Coupling
528.0 Terminal frame (without terminals)
533.0 Terminals for motor/controls
539.0 Screw plug
541.0 Ground connection
553.0 Mechanical position indicator
Socket carrier for motor plug & socket
554.0
connector with cable harness
556.0 Potentiometer as position transmitter
556.1 Potentiometer without slip clutch
557.0 Heater
Please state device type and our order number (see name tag) when ordering
spare parts. Only original AUMA spare parts should be used. Failure to use original
spare parts voids the warranty and exempts AUMA from any liability. Delivered
spare parts may slightly vary from the representation in this manual.
Type
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
-
Sub-assembly
Sub-assembly
Sub-assembly
Ref. no. Designation
Blinker transmitter including pins at
558.0 wires (without impulse disc and insula-
tion plate)
Electromechanical control unit with
559.0-1 switches, including torque switching
heads
Electronic control unit with magnetic
559.0-2
limit and torrque transmitter (MWG)
560.0-1 Switch stack for direction OPEN
560.0-2 Switch stack for direction CLOSE
560.1 Switch for limit/torque
560.2-1 Switch case for direction OPEN
560.2-2 Switch case for direction CLOSE
566.0 RWG position transmitter
Potentiometer for RWG without slip
566.1
clutch
566.2 Position transmitter board for RWG
566.3 Cable set for RWG
567.1 Slip clutch for potentiometer
Ex plug & socket connector with termi-
573.0
nal blocks (KES)
583.0 Motor coupling on motor shaft
596.0 Output drive flange with end stop
607.0 Cover
612.0 Screw plug for end stop
614.0 EWG position transmitter
627.0 MWG cover 05.3
629.0 Pinion shaft
S1 Seal kit, small
S2 Seal kit, large
Spare parts list
Type
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
-
-
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
-
Sub-assembly
Set
Set
45