Gira One Operating Instructions Manual page 6

Dimming actuator, 4-gang Standard
Operating modes
– Bus operation: operation via push-button sensors or other bus devices
– Temporary manual control: manual control locally with keypad, automatic re-
turn to bus control
– Continuous manual mode: Exclusively manual operation on the device
No bus operation is possible in manual mode.
After a bus failure and restoration the device switches to bus operation.
Switching on temporary manual operation mode
￭ Press button ǃ (6) briefly.
LED ǃ (7) flashes, LED A1... (4) of the first configured output flashes.
Short-time manual operation is switched on.
After 5 s without a button actuation, the actuator returns automatically to bus
operation.
Switching off temporary manual operation mode
The device is in short-term manual mode.
￭ No button-press for 5 s.
- or -
￭ Press ǃ (6) button briefly as many time as necessary until the actuator
leaves the short-time manual mode.
Status LED A1... (4) no longer flash, but rather indicate the output status.
Short-time manual operation is switched off.
When switching off manual operation, the outputs, depending on the program-
ming, switch to the active position.
Switching on permanent manual operation mode
￭ Press the ǃ (6) button for at least 5 s.
LED ǃ (7) lights, LED A1... (4) of the first configured output flashes.
Continuous manual mode is switched on.
Switching off permanent manual operation mode
The device is in continuous manual mode.
￭ Press the ǃ (6) button for at least 5 s.
LED ǃ (7) is off.
82402732 07.06.2021
6 / 17