Z Standby Function; Z Optical Interface; Z Default Language; Z Mains Power - Schulthess TW 7000 Instructions For The Use

Standby function (ex factory OFF-MODE)
Select «Extended basic settings»!
"OFF"
The machine always remains switched on. The display
stays switched on (?).
"STANDBY-MODE"
Max. 4 minutes after the end of the programme the
machine switches off in energy saving mode. The display
will show «ZZZ».
"OFF-MODE"
Max. 4 minutes after the end of the programme the
machine automatically switches off. The display will be
dark.
"STANDBY + OFF-MODE"
Max. 4 minutes after the end of the programme the
machine switches off in energy saving mode. The display
will show «ZZZ».
Max. 10 minutes later the machine automatically switches
off. The display will be dark.
Note
If the display is dark, it can be activated by pressing
any button.
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Default language (ex factory DEUTSCH)
Select «Extended basic settings»!
If another language is temporarily selected via the
select-language button
after programme end, in standby mode or after a long
standstill, the setting reverts back to the default
language.
Mains power
400V 2N ~ 3,4kW / 10A
Information for testing institutes and users
The standard cotton programme is called «COTTON,
CABINET DRY» on the display and in the operating
instructions.
Consumption according to Directive 2010 / 30 / EU
Average programme duration
at half and full load
Annual energy consumption
or the buttons and ,
72 min.
305 kWh
64

Cleaning and Care

Cleaning the filters
See chapter «Start programme».

Cleaning the filter support

From time to time it is necessary to remove fluffs that
have accumulated inside the filter support. To do so, use
a vacuum cleaner or a cleaning brush.
X Pull both filters out of the filter support in the door
opening.
X Run the pipe of the vacuum cleaner or the brush around
the well of the filter support.
X Remove any residual fluff.
X Replace the two filters properly.
X Close the door.

Cleaning the moisture sensor

After longer operation, small deposits (lime, fabric
refiner) can form on the front inner side of the drum
on both sides of the longish moisture sensors. With
moisture controlled programmes, this can result in the
desired level of dryness not being reached.
Wipe deposits away with a cloth soaked in vinegar.