Switching Off The Machine - Schulthess TW 7000 Instructions For The Use

Cleaning the filter A / Clean after every drying
programme
X Press the «Open door» button..
X Pull out the inner, fine filter and swing it open.
X Rub your hand over the filter and remove the fluff.
It may happen that a supposedly proper cleaned fil-
ter becomes impermeable, due to a fine, invisible coat
remaining in the filter meshes.
X Hold the filter with one flat surface up wards and pour
a little water on to it. If it is impermeable, clean the filter
with a brush under running water.
 If the coat cannot be brushed away, a commercial
descaler spray must be used to dissolve it.
X Spray the descaler on the entire filter surface and
leave it to take effect. In case of stubborn coats place
one layer of kitchen roll onto the filter surface and spray
descaler on it to ensure the filter is moist. Leave the
descaler to take effect overnight. Then clean the filter
under running water with a fine brush.
Cleaning the filter B / Clean daily
The outer coarse filter (B) must be removed and cleaned
every day.
62
Filter C, below / Clean daily
X Press the button; the maintenance valve springs open.
X Rotate the two fastening levers against one another
in the direction of the arrows.
X Pull the filter (C) out
X Brush the filter with the hand or a damp towel,
removing the lint.
X Replace the filter and secure the blue lever.
X Close the maintenance valve.
Never operate the machine with damaged lint filters.
X Lint filters are consumables and replacements can be
ordered from our customer service department.

Switching off the machine

X Close the door.
X Switch the machine off at the wall.
 If there is not wall switch, the display field will auto-
matically go out, and the dryer will switch to OFF mode
(see chapter «sExtended basic settings/ Standby func-
tion»).