Siemens SIMOTICS M 1PH8 Configuration Manual page 33

Sound pressure level
in accordance with DIN EN ISO 1680, max.
tolerance +3 dB, external fan 50 Hz
Bearing versions and maximum speeds
Encoder systems, built-in
without
DRIVE-CLiQ interface
Encoder systems, built-in
with
DRIVE-CLiQ interface
Connection
Rating plate (adhesive label)
Paint finish
Options
Approvals, in accordance with
1PH8 SIMOTICS M main motors
Configuration Manual, 12/2022, A5E51895839A
3.2 Technical characteristics and environmental conditions
SH 80 ... SH 132: 70 dB at a rated pulse frequency of 4 kHz and a
speed range up to 5000 r/min
SH 160: 73 dB at a rated pulse frequency of 4 kHz and a
speed range up to 5000 r/min
SH 180 and SH 225: 73 dB at a rated pulse frequency of 2 kHz and a
speed range:
Forced ventilation (IP55)
•
•
Open-circuit ventilation (IP23)
•
•
SH 280 74 dB at a rated pulse frequency of 2 kHz and a
speed range: up to 3300 r/min
Forced ventilation (IP55)
•
Open-circuit ventilation (IP23)
•
See Chapter "Mechanical properties of the motors"
• Absolute encoder EnDat 2048 S/R (AM2048 S/R encoder)
• Incremental encoder sin/cos 1 Vpp 2048 S/R with C and D tracks (en‐
coder IC2048S/R)
• Incremental encoder sin/cos 1 Vpp 512 S/R without C and D tracks
(encoder IN512S/R)
• Incremental encoder sin/cos 1 Vpp 256 S/R without C and D track
(encoder IN256S/R)
• Incremental encoder HTL 1024 S/R (encoder HTL1024 S/R)
• Incremental encoder HTL 2048 S/R (encoder HTL2048 S/R)
• Absolute encoder 22 bit singleturn + 12 bit multiturn (encoder
AM22DQ)
• Incremental encoder 22 bit with commutation position (encoder
IC22DQ)
• Incremental encoder 20 bit without commutation position (encoder
IN20DQ)
• Incremental encoder 19 bit without commutation position (encoder
IN19DQ)
Connector for signals or DRIVE-CLiQ interface
(mating connector not included in scope of supply)
SH 80 to SH 132: Terminal box NDE top / power connector
SH 160 to SH 225: Terminal box NDE top
SH 280: Terminal box NDE right
1x glued on the motor
1x supplied loose in the terminal box
Standard paint finish anthracite RAL 7016
See Options and Selection and Ordering data
cURus
Motor description
SH180 to 5000 r/min
SH225 to 3500 r/min
SH180 to 3000 r/min
SH225 to 2000 r/min
SH280 to 3300 r/min
SH280 to 2800 r/min
31