Siemens SIMOTICS M 1PH8 Configuration Manual page 241

Note
Signal connection for special orders
The signal connection may differ from the standard layout in the case of special orders.
For the device version without speed encoder, there is an M16 x 1.5 connection thread.
Power connector connection
• Use connector size 1.5.
• Assign the connector as shown in the "Power connector 1.5" diagram. Connect the protective
conductor.
Figure 9-21
Note
Rotating the connectors
• The permissible rotation range must not be exceeded.
• In order to guarantee the degree of protection, max. 10 revolutions are permissible.
• Connectors should be rotated using the matching mating connector located on the
1PH8 SIMOTICS M main motors
Configuration Manual, 12/2022, A5E51895839A
Power connector, size 1.5 (view of connector pins)
Connector
Connector size 1.5
connector thread. Only rotate the Sensor Module by hand. The use of pipe wrenches,
hammers, or similar is not permitted.
Rotation range
270°
Electrical connection
9.3 System integration
Maximum torque
20 Nm
239