Siemens SIMOTICS M 1PH8 Configuration Manual page 190

Motor components and options
5.2 Options
Adequately dimensioned connecting cables, torsion, strain and shear relief as well as anti-kink protection are
provided for the connection cables.
The protective conductor (only for protection class I) is connected at the grounding point.
There is no foreign matter, dirt or moisture in the terminal box.
Unused cable entries and the terminal box itself are sealed so that the specified degree of protection ac‐
cording to EN 60529 is maintained.
⑤
5.1
5.2
5.3
Figure 5-6
• Connect the spring-applied single-disk brake module to the direct voltage. Use a rectifier
bridge or half-wave rectifier for electrical connection to an AC power system.
• For brakes with integrated rectifiers, you can connect the spring-applied single-disk brake
module directly to alternating voltage.
• See the figure for the terminal assignment.
• For brakes with a connecting terminal, you must connect the brake module directly to direct
voltage. Connect the customer-specific connection cable to the terminals or to the integrated
rectifier. Use a screwed cable gland (M16 x 1.5) for the connection.
• You must remove the cover of the terminal box to connect the individual cores of the
connecting cable to the connecting terminals or to the terminals of the integrated rectifier.
188
Check
5 5.1 5.2
Terminal box
Cover
Connecting terminal or rectifier
Fixing screw for cover
Holding brake terminal box
5.3
⑤
optionally with terminal or rectifier
Configuration Manual, 12/2022, A5E51895839A
OK
1PH8 SIMOTICS M main motors