Checking The Transmission Fluid Level; Checking The Coolant Level - Kubota MX Series Operator's Manual

PERIODIC SERVICE
7. If the engine-oil-level is too low, add new engine oil
to the prescribed level at the oil inlet.
(See LUBRICANTS, FUEL, AND COOLANT on
page 118)
(1) Oil inlet
(2) Dipstick
IMPORTANT :
• When using an engine oil of different maker
or viscosity from the previous one, remove
all of the old engine oil.
Never mix 2 different types of engine oil.
• If the engine-oil-level is low, do not run the
engine.
NOTE :
• At times a small amount of fuel, which is
used to regenerate the DPF, may get mixed
with the engine oil and the engine oil may
increase in volume.
6. Checking the transmission fluid
level
WARNING
To avoid personal injury or death:
• Park the tractor on a firm, flat, and level surface,
lower the implement to the ground, and shut off
126
(A) Range which engine oil level
is acceptable within
the engine before checking the transmission-
fluid-level.
1. Park the machine on a flat surface.
2. Lower the implement.
3. Shut off the engine.
4. View the transmission-fluid-level
transmission-fluid-level-gauge.
(1) Gauge
(2) Oil inlet
5. If the transmission-fluid-level is too low, add new
transmission fluid to the prescribed level at the oil
inlet.
(See LUBRICANTS, FUEL, AND COOLANT on
page 118)
IMPORTANT :
• If the transmission-fluid-level is low, do not
run the engine.

7. Checking the coolant level

WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the
starter key before checking the coolant level.
• Do not remove the radiator cap while the
coolant is hot. When the coolant is cool, slowly
rotate the radiator cap to the first stop and allow
sufficient time for excess pressure to escape
before removing the radiator cap completely.
1. Check to see that the coolant level is between the
"FULL" and the "LOW" marks of the recovery tank.
DAILY CHECK
through the
(A) Range which transmission
oil level is acceptable within
MX5400,MX6000