Engine Error Code; Power Train Troubleshooting - Kubota MX Series Operator's Manual

TROUBLESHOOTING

ENGINE ERROR CODE

If engine trouble should occur, the engine-warning-
indicator will appear and the error code that starts with
either [P] or [U] will appear on the liquid-crystal-display.
If the error code appears, please contact your local
KUBOTA Dealer for repairs immediately.
(1) Engine warning indicator
NOTE :
• Error code will not disappear even if the engine-
warning-indicator is reset.
POWER TRAIN
TROUBLESHOOTING
If something is wrong with the power train, the master-
system-warning-indicator starts blinking and the error
code shown in the following table is displayed on the
liquid-crystal-display, indicating the location of the
trouble. If an error code appears, immediately contact
your local KUBOTA Dealer for repairs.
(1) Master system warning indi-
cator
162
(2) Error code
(2) Error code
Displayed
Trouble
error code
Communication trou-
E-20
ble
CAN communication
E-21
trouble
Accelerator adjust-
E-30
ment trouble
Input voltage of lever
E-40 sensor from ECU is
in trouble.
Acceleration sensor
E-84
maladjusted
Relay for engine-
E-93 starter-motor is in
trouble.
Relay for engine-
E-94
shut-off is in trouble.
Solenoid (PTO) is in
E-95
trouble.
ENGINE ERROR CODE
Operator's action
Contact your local KUBO-
TA Dealer.
Contact your local KUBO-
TA Dealer. The engine
cannot start.
Contact your local KUBO-
TA Dealer. The operator-
presence-control (OPC)
system gets activated, and
the engine stops itself.
Contact your local KUBO-
TA Dealer. The PTO shaft
cannot rotate.
MX5400,MX6000