Checking Transmission Fluid Level; Checking Coolant Level; Cleaning Evacuator Valve; Checking Dust Indicator - Kubota M6060 Operator's Manual

BChecking Transmission Fluid Level
1. Park the machine on a flat surface, lower the
implement and shut off engine.
2. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the 2 notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Dipstick (A) Oil level is acceptable within this range.
(2) Oil inlet
A If oil level is low, do not run engine.
BChecking Coolant Level
To avoid personal injury or death:
A Do not remove radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Check to see that the coolant level is between the
"FULL" and "LOW" marks of recovery tank.
2. When the coolant level drops due to evaporation, add
soft water only up to the full level.
In case of leakage, add anti-freeze and soft water in
the specified mixing ratio up to the full level.
(See "Flushing Cooling System and Changing
Coolant" in "EVERY 2000 HOURS or 2 YEARS" in
"PERIODIC SERVICE" section.)
3. When the coolant level is lower than "LOW" mark of
recovery tank, remove the radiator cap and check to
see that the coolant level is just below the port. If level
is low, add coolant.
(1) Recovery tank
A If the radiator cap has to be removed, follow the
caution above and securely retighten the cap.
A Use clean, fresh soft water and anti-freeze to fill the
radiator.
A If coolant should leak, consult your local KUBOTA
Dealer.
BCleaning Evacuator Valve
Open the evacuator valve to get rid of large particles of
dust and dirt.
(1) Evacuator valve
BChecking Dust Indicator
There is a dust indicator on the air cleaner body. If the red
signal on the dust indicator is visible, clean the element
immediately. (See "Cleaning Air Cleaner Primary
Element" in "EVERY 100 HOURS" in "PERIODIC
SERVICE" section.) Reset the red signal by pushing a
"RESET" button after cleaning.
PERIODIC SERVICE
(A) "FULL"
(B) "LOW"
87