Checking Transmission Fluid Level; Checking Coolant Level - Kubota B2301-1 Operator's Manual

BChecking Transmission Fluid Level
1. Park the machine on a flat surface, lower the
implement and shut off engine.
2. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies within the crosshatched area.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Oil inlet (A) Oil level is acceptable within this range
(2) Dipstick
A If oil level is low, do not run engine.
BChecking Coolant Level
To avoid personal injury or death:
A Do not remove radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Check to see that the coolant level is between the
"FULL" and "LOW" marks of recovery tank.
2. When the coolant level drops due to evaporation, add
soft water only up to the full level.
In case of leakage, add anti-freeze and soft water in
the specified mixing ratio up to the full level.
(See "Flushing Cooling System and Changing
Coolant" in "EVERY 2 000 HOURS or 2 YEARS" in
"PERIODIC SERVICE" section.)
(1) Recovery tank
A If the radiator cap has to be removed, follow the
caution above and securely retighten the cap.
A Use clean, fresh soft water and anti-freeze to fill the
recovery tank.
A If water should leak, consult your local KUBOTA
Dealer.
PERIODIC SERVICE
(A) "FULL"
(B) "LOW"
55