Installation - Dantherm CD400 ECO Instructions For Use Manual

Installation

Place the appliance in the room that you wish to dehumidify.
It is essential to leave a space of at least 50 cm. around the appliance in order to ensure adequate ventilation.
The condensation can be discharged in one of two ways:
A) Discharge into the canister
The condensation generated by the dehumidifier can be discharged directly into the canister which is
located inside the appliance (fig. 1).
The canister is easy to extract when it needs to be emptied. It has an ergonomic form and is equipped with
a handle which makes it easy to carry and to empty.
B) External discharge
The condensation can be continually drained out of the canister by fitting a drain outlet pipe and hose to
the canister.
1) Drill a hole in the area marked on the union so that the condensation water in the canister can drain
out.
2) Fit the seal ring, outlet pipe and the ring nut to canister union (see fig. 2).
3) Place the canister inside the appliance.
4) The housing door features a pre-marked hole for the condensation drain hose (fig. 3). Remove the
centre disk and pass the hose through the hole.
N.B. If you want to go back to collecting the condensation in the canister, remove the outlet pipe, fit the
blanking seal and fix it in place using the ring nut.
Canister Control System
This dehumidifier is equipped with a special intelligent device which checks that it is working properly.
A warning lamp placed on the control panel comes on to warn the user when:
1. the canister is full
2. the canister is missing
3. the canister is badly positioned
4. you are using the continuous discharge and there is a blockage in the hose or the hose goes "uphill"
remove the blockage.
Once the cause has been removed, the warning lamp goes off and the appliance starts working again.
12
Fig. 1
Fig. 2
empty the canister
put the canister back into position
position it correctly
Fig. 3