Maintenance - Dantherm CD400 ECO Instructions For Use Manual

Maintenance

Always remove the plug from the power socket before performing any cleaning or maintenance operations.
For safety, never use a jet of water to wash the appliance.
Cleaning the cabinet
• Clean the appliance using a damp cloth and dry using a dry cloth.
• Never use petrol, methylated spirits or solvents to clean the appliance.
• Never spray the appliance with insecticides or similar products. These may cause the paint to flake or the
pastic parts to become mis-shapen.
Cleaning the air filter
• The filter should be cleaned weekly.
• To remove the filter, open the canister access panel, remove the
canister and remove the filter by pulling downwards (fig. 4).
• Use a vacuum cleaner to remove the dust that builds up on the filter.
If the filter is very dirty, wash it in warm water and rinse several times.
The temperature of the water should not exceed 40°C.
After washing the filter, allow it to dry completely before replacing
it in the appliance.
If the appliance is not used for long periods
• Disconnect the plug from the power socket and empty the canister.
• Clean and replace the filter.
• Protect the appliance from dust by covering with a large plastic
bag.
Model CD400 ECO only
• Do not cover this appliance with bags when it is not in use
• Do not place this appliance in rooms smaller than ls 8m
Important
• This appliance is designed to dehumidify domestic living areas, and must not be used for other
purposes.
• The appliance must not be modified in any way, as any modifications may be extremely dangerous.
• If the appliance requires repair, always contact a Service Centre authorized by the manufacturer.
Always insist on original spare parts. Repairs carried out by non-qualified personnel may be
dangerous and render the warranty null and void.
• This appliance must be used by adults only. Do not allow children to play with the appliance.
• The appliance must be adequately earthed. Have your electrical circuit checked by a qualified
electrician.
• Do not use extension power cables.
• Always remove the plug from the socket before performing cleaning or maintenance operations.
• Do not move the appliance by pulling the power cable.
• Do not install the appliance in areas containing gas, oil or sulphur. Do not install the appliance near
sources of heat.
• After switching off the appliance, always wait at least three minutes before switching it on again.
• Do not place heavy or hot objects on the top of the appliance.
• Clean the air filter at least once weekly.
• The appliance must always remain upright or laid on one side during transportation. Remember to
drain the canister before transporting the appliance.
After transporting the appliance, wait at least one hour before using it.
14
Fig. 4
3