Set Up Vnc Software On Ios Devices - ABB GLA232 Series User Manual

ABB LGR-ICOS™ GLA232 Series Methane/Ethane Analyzer User Manual

Set up VNC Software on iOS Devices

1. On the iOS device, go to Settings > WiFi, then select the network from the list.
2. Connect to the wireless SSID network listed on the router sticker. (Figure 36) Enter the
TP-Link wireless router (example: IBR200-xxxx). See Figure 37 for the location of the
wireless router on the analyzer.
3. Select your SSID network. For example, TP-LINK-D036. (Figure 44)
4. The Enter Password screen appears. (Figure 45) In the Password field, enter the
wireless password on the router sticker. (Figure 36)
5. Select Join.
6. The Network Connections screen confirms that the iOS device is connected to the
router. (Figure 46)
7. Select the network to check the IP address (192.168.100.100 or 192.168.100.101) of the
device as shown in Figure 47.
Wireless devices can compete for dynamic addresses. If the 192.168.100.100 address
does not connect, use 192.168.100.101.
ABB PROPRIETARY INFORMATION
Figure 44: Network Connections Screen
Figure 45: Router Connection Screen
Figure 46: Router Connection Confirmation Screen
56