Restarting The I/O Module; Setting The Ip Address For Bridges - HP J2000 Maintenance And Operation

• Netmask
• Gateway
6. Click Save.
7. Close the Settings window by clicking the X in the upper right corner of the window.

Restarting the I/O module

Prerequisites
Requires Administrator or Operator privileges
Procedure
1. In the WebUI, click the IOMs tab.
2. Select the IOM tab (IOM 1 or IOM 2) whose settings you want to change.
3. To access and change IOM network information, click Settings.
4. Click Soft Reset IOM.
5. Close the Settings window by clicking the X in the upper right corner of the window.

Setting the IP address for bridges

Prerequisites
Requires Administrator or Operator privileges
Procedure
1. Navigate to the BRIDGES tab.
2. Select a bridge.
Use the Ethernet port settings section of the WebUI to configure IP address settings.
3. DHCP is controlled for the Ethernet port option on each bridge by using the DHCP slide toggles. The host
management IP ports are configured for DHCP by default.
• Disable DHCP to set static network addresses. Click the Edit icon to edit the IP address, netmask, and gateway for
the bridge, and then click Save. Repeat this for each of the additional bridges.
• If DHCP is enabled, the bridge IP addresses cannot be edited.
HPE recommends setting the IP addresses of the bridges on both IOMs to the same subnet. This allows multiple paths
to the same devices.
NOTE: Non-IP Bridge parameters are also available for configuration. These will prompt the user for confirmation of
each configuration change.
13
Operation