Table of Contents
Advertisement
Operation
WebUI overview
The J2000 WebUI enables system administrators to connect the NVMe-oF bridge adapter card(s) to a target NVMe
Qualified Name (NQN) for each drive and to set up the hosts.
SYSTEM SUMMARY
The SYSTEM SUMMARY is a static display of high-level system information at the top of the window. Below the system
summary are tabs for system management and information: CHASSIS, DRIVES, HOSTS, IOMS, BRIDGES, and
INVENTORY. The status of each component is indicated to the left of the tab name.
Color
Green check mark
Yellow exclamation mark
Red X
CHASSIS tab
The CHASSIS tab is displayed by default when you log in to the WebUI. It provides information about the fans and power
supply units (PSUs), as well as a visual representation of where each component is located in the chassis. Toggle the
chassis and fans Locate switches to the right to locate components by illuminating their identification LEDs.
The CHASSIS tab also displays the following J2000 information:
•
Manufacturer
•
Serial number
•
Part number
•
Chassis temperature
DRIVES tab
The DRIVES tab provides a visual representation of all drives, ordered 1 to 24, from left to right. Drive status is indicated
by color and sometimes by an icon. Drive information also includes the model, firmware version, and health. To illuminate
the blue identify drive LED at the bottom of the drive slot, slide the Locate toggle to the right (ON). The identify LED
goes dark when the toggle is slid to the left (OFF). To turn on power for the selected drive, slide the Power toggle to the
right (ON). To turn power off for the selected drive, slide the Power toggle to the left (OFF).
System status
Good
Warning of a potential fault
Critical issue
6
Operation
Advertisement
Table of Contents
