Installation Of The Perimeter Cable - Stiga G 300 Instruction Manual

4.5.1. INSTALLATION OF THE PERIMETER CABLE

POSITIONING WITH PEGS
CAUTION:
Danger of cutting hands.
Requirements and obligations:
• Low grass all the way
• Perimeter cable
• Fixing pegs
• Joints for perimeter cable
• Pliers
GLOVES OBLIGATION:
Use protective gloves to avoid
cutting your hands.
Procedure:
1. Place the perimeter cable (A) starting from the docking station installation area.
2. Place the cable along the entire path, fi xing it with the suitable pegs (B) spaced approximately 100
cm apart, and observing the installation requirements (See Par. 4.3 and Par. 4.4).
3. Leave 2 m of cable or more to subsequently cut it to size in the fi nal phase of connection.
NOTE: In non-straight sections, make sure that the cable (A) does not get tangled. Position the
cable in such a way as to form a regular curve with a radius of about 20 cm
NOTE: The perimeter cable used for installation must be at least 40 m. long. If the cable is
shorter, it will be necessary to install the resistor for small perimeters. (See Par. 4.5.4. and
Chap. 9 "Accessories").
WARNING:
Make sure that the cable is in contact with the ground along its path to prevent
the robot lawn mower from damaging it.
24
4. INSTALLATION
A
CAUTION:
Danger of dust in the eyes.
• Hammer
• Gloves
• Glasses
• Electrician's scissors
GLASSES OBLIGATION:
Use safety glasses to avoid the
danger of dust in the eyes.
B
EN