Functioning Of The Docking Station; Battery Charging - Stiga G 300 Instruction Manual

5.4.

FUNCTIONING OF THE DOCKING STATION

The docking station is equipped with an indicator light (N) that lights up in the following manner:
• Warning light off : the docking station is powered off or the robot is on the base.
• Steady indicator light: the perimeter cable is correctly connected to the charging base, and the
perimeter signal is correctly transmitted;
• Indicator light fl ashing slowly: the perimeter cable is not connected or is interrupted (the perimeter
cable integrity check is not performed continuously, but only when the robot leaves the charging
base or the base is powered);
• Warning light fl ashing quickly: the perimeter cable is too short (see Par. 4.5.4) or there is a fault in
the docking station.
• Indicator light fl ashing rapidly twice or three times: the docking station has detected a short circuit
on the charging contacts. (See Chapter 7).
5.5.

BATTERY CHARGING

The "BATTERY CHARGING" procedure allows to recharge the robot lawn mower manually.
Requirements and obligations:
• Docking station connected to the mains.
Procedure:
1. Position the robot lawn mower on the docking station (R).
2. Slide the robot lawn mower onto the docking station, until the charging connector (S) is engaged.
3. Press the "STOP" button (A) to open the cover (B) and access the control panel (C).
4. Turn the robot lawn mower on with the "ON/OFF" button (E).
5. When the "BATTERY" icon (O) fl ashes blue, the robot lawn mower is charging.
6. Close the cover (B).
7. Leave the robot lawn mower to charge for at least the time shown in Par. 4.6.
NOTE: Charging the battery before winter storage should be carried out as shown in Par. 6.4.
A
EN
R
C B S
N
O
E
5. OPERATION
43