Resistor Installation For Small Perimeters - Stiga G 300 Instruction Manual

9. Secure the docking station (L) to the ground with the fixing screws (M).
10. Reposition the cover (C).
11. Connect the power supply connector to the docking station and then insert the power supply plug
into the electrical outlet.
12. When the robot lawn mower is not in the charging base, make sure that the indicator light on the
charging base (N) is lit with a fixed light (see Par. 5.4)
WARNING:
The power cable, power supply unit, extension cord and all other electric cables
which do not belong to the product must remain outside the cutting area to
maintain their distance from hazardous moving parts and prevent damage to
cables which may come into contact with live parts.
L
NOTE: If necessary, it is possible to extend the power cable to the docking station by using
the extension cables. It is permitted to use a maximum of two 5-meter extension cables (See
Chapt. 9 "Accessories").

4.5.4. RESISTOR INSTALLATION FOR SMALL PERIMETERS

Requirements and obligations:
The perimeter cable used for the installation of the robot lawn mower must be at least 40 m. long. If the
cable length is shorter, it is necessary to connect in series the resistor (See Ch. 9 "Accessories") with the
perimeter cable.
Procedure:
After having positioned and secured the docking station correctly (see par. 4.5.3), proceed as follows:
1. Remove the cover (C).
2. Cut the ends of the cables to the exact length.
3. Apply the self-drilling connectors on the cable (F), (G), (H). (See par. 4.5.3).
4. Connect the resistor (O) to the terminal (I) of the docking station.
5. Connect the respective perimeter cable to the resistor (O).
6. Connect the other perimeter cable directly to the other terminal of the docking station.
28
4. INSTALLATION
C M
O
N
EN