Walkways From One Area Of The Garden To Another; Components Installation - Stiga G 300 Instruction Manual

Hide thumbs Also See for G 300:
Table of Contents

Advertisement

4.4.3. PASSAGES AMONG DIFFERENT AREAS OF THE GARDEN
Procedure:
1. In the case of corridors, the distance between two different sections of the perimeter cable must be
Z ≥70 cm.
2. In case of passage between two different sections of cable Z <70 cm, the area (A) is to be
considered a"Closed Area" and cannot be reached by the robot lawn mower automatically.
NOTE: For programming the robot lawn mower relating to the configuration of the garden with
"Closed Area" please refer to the procedure at Par . 4.7.5 "Closed Area".
4.5.

COMPONENTS INSTALLATION

ELECTRICAL HAZARD:
Only use the battery charger
and power supply provided by
the manufacturer. Improper use
may cause electric shock and\or
overheating.
ELECTRICAL HAZARD:
A socket must have been
prepared near the installation
area to connect it to electricity.
Make sure that connection
to the power supply network
conforms to laws in force of the
Country where it is used.
EN
Z
A
CAUTION:
The circuit provided must be
protected by a residual current
device (RCD) with an activation
current not exceeding 30 mA.
ELECTRICAL HAZARD:
Connect the power supply only
at the end of all the installation
operations. If necessary during
the installation, turn off the
general power supply.
4. INSTALLATION
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

G 600G 12008008984855465

Table of Contents