Keysight Technologies X Series Custom Installation Notes page 19

Figure 11 ODI Heatsink Thermal Pads and Gasketing
ODI Cable Installation
The ODI cable provided in this kit has two connectors that need to be installed on the A21
Wideband Digital IF assembly. One is blue and the other is orange. The blue connector is the
receiver end, and the orange is the transmitter, so they need to be installed in the correct location
on the A21 assembly, as seen in
the connectors on the left as seen in
Figure 12 ODI Cable Connector Locations
There is a tool included in this kit that needs to be used to install these connectors, as seen in
Figure 13. The following procedure will describe and illustrate how this tool is used.
Figure 13 ODI Connector Tool
Installation Note N9042-90011
Figure 12. Also, the option ST1/2 cable connectors must go into
Figure 12.
Option ST1 and ST2 – IQ Streaming
19