Table of Contents
Advertisement
Spectre Integra-M/MA Assembly Manual
FRONT BUTTON HEADER: connect the main power button from the front panel here:
POWER SW cable to PWR (PowerBoard), polarity does not matter.
POWER LED+/- to LED (PowerBoard), polarity does not matter.
Powering on the system:
There are up to 4 ways to turn the system on. The first is the main power button that's installed
onto the front of the case. Second is the built-in buttons on the PowerBoard. Third is the touch
button on the back side, bottom right corner area of the PowerBoard inside the acrylic cut out,
touch the Singularity Computers logo to turn the system on. Fourth is the power button built into
the motherboard, it depends on the model whether it has it or not.
SATA Connector:
Connect this SATA input into a SATA output on the motherboard and install a 2.5" drive into the
PowerBoard. There is no need to connect a SATA power cable to the 2.5" drive, it is powered
directly from the PowerBoard.
Revision 1.1
Page | 26
Advertisement
Table of Contents
Need help?
Do you have a question about the SPECTRE INTEGRA-M and is the answer not in the manual?
Questions and answers