Installation; Safety; Pneumatic Installation - Festo MS6-SV D-10V24 Series Operating Instructions Manual

Installation

Fig. 8: Assembly
1. Slide the cover cap MS6-END 1 upwards and remove it.
2. Insert a seal 2 between the separate devices (module connector in scope of delivery).
3. Place the module connector 2 in the slots of the separate devices.
4. Fasten the module connector with two screws (module connector in scope of delivery).
Tightening torque: maximum 1.2 Nm
6 Installation
6.1

Safety

WARNING
Risk of injury from compressed air.
• Before carrying out installation and maintenance work, switch off the compressed air supply.
6.2

Pneumatic installation

Port 1 and 2
If using screw connectors:
1. Note the screw-in depth of the connector thread: 10 mm.
2. Make sure that the compressed air lines are connected correctly.
3. Screw the fittings into the pneumatic ports using a suitable sealing material.
16
1
2
3
Festo — MS6-SV-...-D-10V24 — 2022-06c