Ppc-3712 Back Cover Removal; Jp1: Cf Card Setup; Jp4: Clear Cmos Setup; Figure 3-4: Ppc-3712 Back Cover Retention Screws - IEI Technology PPC-3708 User Manual

PPC-3708/PPC-3710/PPC-3712 Panel PC

3.5.1.3 PPC-3712 Back Cover Removal

The back cover is secured to the chassis with nine retention screws, six on the rear panel
and three on the top panel (Figure 3-4). Remove the nine retention screws and lift the
cover off the PPC-3712.

Figure 3-4: PPC-3712 Back Cover Retention Screws

3.5.2 JP1: CF Card Setup

The CF Card Setup jumper configures a CF card as either the slave or the master.
JP1
Open Slave (Default)
Close Master

Table 3-1: CF Card Setup Jumper Settings

3.5.3 JP4: Clear CMOS Setup

If the motherboard fails to boot due to improper BIOS settings, use this jumper to clear the
CMOS data and reset the system BIOS information. To do this, use the jumper cap to
close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1 and 2.
DESCRIPTION
Page 53