Grandstream Networks WP810 Series Administration Manual page 35

Specifies matching rules with number, pattern, or Alert Info text (up to 3 matching rules). When the incoming
caller ID or Alert Info matches the rule, the phone will ring with selected distinctive ringtone. Matching rules:
Specific caller ID number. For example, 8321123.
A defined pattern with certain length using x and + to specify, where x could be any digit from 0 to 9.
Samples:
xx+: at least 2-digit number.
Match
xx: only 2-digit number.
Incoming
Caller ID
[345]xx: 3-digit number with the leading digit of 3, 4 or 5.
[6-9]xx : 3-digit number with the leading digit from 6 to 9.
Alert Info text: Users could configure the matching rule as certain text (e.g., priority) and select the
custom ring tone mapped to it. The custom ring tone will be used if the phone receives SIP INVITE with
Alert-Info header in the following format: Alert-Info: <http://127.0.0.1>; info=priority
When the incoming caller ID or Alert Info matches one of the 10 rules, the phone will ring with the
associated ringtone
Ring Defines the timeout (in seconds) for the rings on no answer. The default setting is 60. The valid range is from
Timeout 10 to 300.
Account/Intercom Settings
Allow Auto
Answer by
If set to "Yes", the phone will automatically turn on the speaker phone to answer incoming calls after a short
Call-
reminding beep, based on the SIP Call-Info/Alert-Info header sent from the server/proxy.
Info/Alert-
Info
Allow
When enabled, the phone will automatically put the current call on hold and answer the incoming calls
Barging by
based on the SIP Call-Info/Alert-Info header sent from the server/proxy. However, if the current call was
Call-
answered based on the SIP Call-Info/Alert-Info header, then all other incoming calls with SIP Call-Info/Alert-
Info/Alert-
Info headers will be rejected automatically.
Info
Custom
Alert-Info Used exclusively to match the contents of the Alert-Info header for auto answer. The default auto answer
for Auto headers will not be matched if this is defined.
Answer
Account/Feature Codes
Enable Local Call Features
Table 19: Account/Call Settings
Table 20: Account/Intercom Settings
When enabled, Do Not Disturb, Call Forwarding and other call features can be used via the local
feature codes on the phone. Otherwise, the provisioned feature codes from the server will be
used. User configured feature codes will be used only if server provisioned feature codes are
not provided. And once feature codes are configured, either via server provisioning or local
setting, a Softkey named "Features" will show on the LCD screen.
Note: If the device is registered with Broadsoft account, it doesn't matter if local call features
are enabled or disabled, once the Broadsoft account is set, special feature to Broadsoft and