Table of Contents
Advertisement
DIVAR IP all-in-one 6000
4
Preparing for installation
Read this section in its entirety before you begin the installation.
4.1
Choosing the installation location
–
–
–
–
Notice!
i
This equipment is intended for installation in Restricted Access Location or equivalent.
Notice!
i
This product is not suitable for use with visual display work place devices according to §2 of
the German Ordinance for Work with Visual Display Units.
4.2
Rack precautions
Warning!
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
!
precautions to ensure that the system remains stable. The following guidelines are provided
to ensure your safety:
–
–
–
–
–
–
–
–
4.3
General system precautions
–
–
–
–
–
Bosch Security Systems B.V.
Place the system near at least one grounded power outlet.
Place the system in a clean, dust-free area that is well ventilated. Avoid areas where heat,
electrical noise and electromagnetic fields are generated.
Leave approximately 25 inches (63.5 cm) clearance in front of the rack to be able to open
the front door completely.
Leave approximately 30 inches (70.2 cm) of clearance in the back of the rack to allow for
sufficient airflow and ease in servicing.
Ensure that the leveling jacks on the bottom of the rack are fully extended to the floor
with the full weight of the rack resting on them.
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top
with the heaviest component at the bottom of the rack.
In single rack installations, attach stabilizers to the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack.
In multiple rack installations, couple the racks together.
Always make sure the rack is stable before extending a component from the rack.
Extend only one component at a time - extending two or more simultaneously may cause
the rack to become unstable.
Review the electrical and general safety precautions that came with the components you
are adding to your chassis.
Determine the placement of each component in the rack before installing the rails.
Install the heaviest components on the bottom of the rack first, and then work up.
Use a regulating uninterruptible power supply (UPS) to protect the system from power
surges and voltage spikes if you want to keep your system operating in case of a power
failure.
Allow the hard drives and power supply modules to cool before touching them.
Installation manual
Preparing for installation | en
2022-10 | V02 | F.01U.407.903
19
Advertisement
Table of Contents
