Table of Contents
Advertisement
18
en | Installation - first steps
5
Installation - first steps
DIVAR IP systems are shipped with a pre-installed Configuration
Wizard from factory.
5.1
Setup notes
By default all DIVAR IP systems are configured to obtain a valid
network address from DHCP server in the local network. In
small networks this task is usually performed by an internet
router. If there is no DHCP server in the network, DIVAR IP will
use the following network settings:
–
–
Notice!
We strongly recommend that you do not change any operating
system settings. Operating system access should only be used
for troubleshooting. Changes can result in malfunctioning of the
system.
5.2
Connecting the unit
DIVAR IP system is ready to go out of the box. The application
provides a simple to install and intuitive to use solution for
network surveillance systems.
Connecting the unit:
1.
2.
3.
2014.07 | V1 | DOC
IP Address: 192.168.0.200
Subnet mask: 255.255.255.0
Connect the unit and the cameras to the network.
Connect the unit to the power supply.
Turn on the unit.
A series of scripts perform important setup tasks. This can
take several minutes. Do not turn off the computer.
Note: During this initial setup the system LED is blinking.
After the system is ready for operation, the system LED
stops blinking. The web based wizard pages of the DIVAR IP
DIVAR IP 2000
Bosch Sicherheitssysteme GmbH
Hide quick links:
Advertisement
Table of Contents
