Rack Installation; Installing The Inner Rail Extensions On The Chassis - Bosch DIVAR IP all-in-one 6000 Installation Manual

Hide thumbs Also See for DIVAR IP all-in-one 6000:
Table of Contents

Advertisement

DIVAR IP all-in-one 6000
5

Rack installation

This chapter describes the installation of DIVAR IP all-in-one 6000 in a rack.
You can also watch a video showing the rack installation. To get to the video, scan the
following QR code:
Applicable racks
There is a variety of racks on the market, so that the installation procedure slightly differs
depending on the rack type.
The rack mount kit is adaptable for installation in following rack types:
The delivered rails fit a rack with a depth of 25.6 inches (65.02 cm) to 33.5 inches (85.09 cm).
Notice!
i
For more information, refer to the documentation of the rack that you use.
Prerequisites
To install DIVAR IP all-in-one 6000 in a rack, you need:
Procedure
To install DIVAR IP all-in-one 6000 in a rack, you must do the following:
1.
2.
3.
5.1

Installing the inner rail extensions on the chassis

Caution!
Do not pick up the chassis with the front handles. They are designed to pull the system from
!
a rack only.
To install the inner rail extensions:
1.
2.
3.
4.
Bosch Security Systems B.V.
Square-hole rack
Round-hole rack
Round-hole threaded rack
The rack mount kit delivered with the device. The rack mount kit includes:
Two outer rails (each outer rail consists of two sections, a long section and a short
section).
Two inner rail extensions (in accessory box).
A bag of screws (in accessory box).
A standard Phillips screwdriver.
Installing the inner rail extensions on the chassis, page 21 .
Installing the outer rails to the rack, page 22 .
Installing the chassis in the rack, page 26 .
Place the inner rail extension on the side of the chassis so that it faces "outward" just like
the pre-installed inner rail.
Align the holes on the inner rail extension with the hooks on the chassis.
Slide the inner rail extension toward the front of the chassis.
Optionally: secure the inner rail with one M4 x 6L screw (delivered in the accessory box).
Installation manual
Rack installation | en
2022-10 | V02 | F.01U.407.903
21

Advertisement

Table of Contents
loading

Table of Contents