Hard Drive Tray Leds - Bosch DIVAR IP all-in-one 6000 Installation Manual

DIVAR IP all-in-one 6000
Control panel buttons
Control panel LEDs
Information
3.3

Hard drive tray LEDs

The device supports hot-swappable SATA hard drives in hard drive trays. Each hard drive tray
has two LEDs on the front of the tray.
Bosch Security Systems B.V.
Button Description
The power button is used to apply or remove power from the power supply to
the system.
Note: Turning off system power with this button removes the main power,
Power
but keeps standby power supplied to the system.
To remove all power, unplug the system before performing maintenance
tasks.
The reset button is used to reboot the system.
Reset
LED LED state
This LED indicates the system status.
Solid red
Blinking red
(1 Hz)
Blinking blue
(300 msec)
Green
flashing
NIC2
Green
flashing
NIC1
Not used
HDD
Solid green
Power
Description
An overheat condition has occurred. (This may be caused by
cable congestion.)
Fan failure: check for an inoperative fan.
Remote UID is on. Use this indication to locate the unit from a
remote location through IPMI interface.
This LED indicates network activity when flashing.
This LED indicates network activity when flashing.
This LED indicates that power is supplied to the system's
power supply unit.
This LED is illuminated when the system is operating
Installation manual
System overview | en
2022-10 | V02 | F.01U.407.903
17