Recovering The Unit - Bosch DIVAR IP all-in-one 6000 Installation Manual

DIVAR IP all-in-one 6000
14. In the next dialog box, in the section CHOOSE UNCONFIGURED DRIVES:, select the
15. Then, in the section CHOOSE UNCONFIGURED DRIVES:, select the option Apply
16. In the next dialog box, select the option Save Configuration, then press Enter.
17. In the next dialog box, select the option Confirm, press Enter, then set the status to
18. Press Enter to confirm again.
19. Select OK, then press Enter to continue.
20. Press F4 and Enter to save and exit.
8.6.2

Recovering the unit

To recover the unit:
1.
2.
Notice!
i
Do not turn off the unit during the process. This will damage the recovery media.
3.
4.
5.
6.
Bosch Security Systems B.V.
option Check All, then press Enter.
Changes, then press Enter.
You receive a confirmation that the operation was performed successfully. Select OK,
then press Enter to continue.
Enabled, then press Enter again.
You receive the confirmation that the operation was successful.
The DIVAR IP all-in-one 6000 unit restarts.
Turn on the unit and press F7 during the BIOS power-on-self-test to enter Windows PE.
The System Management Utility dialog box is displayed.
Select one of the following options:
– System factory default: This option will format video data partitions and restore the
OS partition with the factory default image.
This process might take up to 5 minutes.
– Full data overwrite and system factory default: This option will format video data
partitions, completely overwriting existing data, and restore the OS partition with
factory default image.
Note: This process might take up to 110 hours.
– OS system recovery only: This option will restore the OS partition with the factory
default image and import existing virtual hard drives from existing video data
partitions.
This process might take up to 5 minutes.
Note:
The OS system recovery only option does not delete video footage that is stored on the
data HDDs. However, it replaces the complete operating system partition (including the
video management system settings) with a default configuration. To access existing video
footage after recovery, the video management system configuration needs to be exported
before the system recovery and re-imported afterwards.
Confirm the selected option.
The system starts the formatting and image recovery process.
After the recovery process is complete, confirm the system restart.
The system restarts and setup routines are performed.
After the process is complete, the Windows language selection screen is displayed.
Proceed with the initial system setup.
Installation manual
System setup | en
2022-10 | V02 | F.01U.407.903
39