Resetting To Factory Settings - Viessmann Vitoconnect OPTO2 Operating Instructions Manual

Measures for troubleshooting
Faults without LED indicator
All indicators on the Vitoconnect
are off.
Restarting the Vitoconnect
After rectifying the fault, the Vitoconnect has to be
restarted.
Simultaneously press the Reset button
operating button for approx. 15 seconds: see chap-
A
ter "Display and operating elements".
■ LED and illuminated in green: The start-up
phase can last up to 2 minutes.
■ LED illuminated in white: Vitoconnect is ready.

Resetting to factory settings

You can reset all changed values to their factory set-
tings.
1. Press the Reset button
see chapter "Display and operating elements".
LED flashes red.
Setting up WiFi after replacing the router
1. Activate the Vitoconnect access point mode: see
page 24.
2. Open the Wi-Fi settings of your smartphone.
3. Connect your smartphone to the
"VITOCONNECT-<xxxx>" Wi-Fi.
4. Enter the WPA2 password.
Note
The WPA2 password can be found on the supplied
sticker.
(cont.)
Measures
Check the power supply and the plug-in power supply unit for the Vitoconnect.
B and the
B for at least 30 seconds:
2. Briefly press reset button
onds.
LED no longer illuminates.
Vitoconnect restarts.
5. Go to the internet browser on your smartphone and
open https://vitoconnect.gateway or
http://192.168.1.1
6. On the starting page, select "Select router".
7. Follow the instructions on the Internet page.
8. Access point mode is automatically deactivated
after 5 min.
Or
Manually deactivate the Vitoconnect access point
mode: see page 24.
What to do?
B again within 5 sec-
27