Table of Contents
Advertisement
position before operating or charging the unit.
To start: Unpack the lifter by removing all protection devices and taking the lifter out of its
carton box.
Step 1: Install the actuator
Install the actuator placing one end on the arm and one
end on the mast of the lifter, thanks to a hinge. Secure
the installation by introducing one spacer and fixing it
with two bolts, one at each side.
procedure for the other end.
The bolts are coated by the "LOCTITE 243" to avoid the loss of screws during the lifting
operating mode.
The "LOCTITE 243" is a medium thread lock coated on the screws during the
manufacture for the future installation to the customers.
Tighten with a hexagonal wrench or the provided special wrench, without using too much force:
the screw head would be deteriorated and it would be impossible to dismount it later.
These operations are very important for the security of the patient and
caregivers.
Without the security pins, the column or the arm may fall and provoke
serious injuries. You must ensure that these pins are properly secured
and perform regular inspections: screws must ALWAYS be present and
in good condition. A label near the pins allows a quick identification for
inspection.
Step 2: Install the column on the base
8
Follow the same
DOMU125_EN_v3_20221205_Poweo® Quick Up user manual
Advertisement
Table of Contents
