Scaleo medical Poweo 140 Quick Up User Manual page 16

To charge the SCALEO® battery :
1. Connect the charger to the
AC outlet,
2. Place the battery in the
battery charger,
3. Once the battery is detected
in the charger, the LED
indicator lights up.
The Poweo ® 140 - 180 Quick Up will
take from 2h30 to 5 hours to
completely recharge to 100% an empty battery.
For intensive daily use a daily recharge will be necessary.
The batteries cannot be overcharged. However, to ensure better performance and
longevity, it is recommended to let them rest for a few minutes after charging and
before use. It is also important to fully charge the battery.
Upon request, the charger's power connector can be delivered protected by a plug that
ensures additional protection of the charger against splashing water. Remove this plug
for charging, and be sure to replace it after recharging.
To charge the patient lifter, use only the supplied cable: charging a battery with an
unsuitable cable can cause the cable and/or battery to overheat and damage all
components, or cause a fire.
After each charge, be careful to unplug the power cord without pulling it to avoid
damaging the cord.
It is recommended to have 2 batteries to replace the discharged battery with the
charged one. Therefore, Poweo® will remain functional at all times.
16
Charge
status
label
DOMU125_EN_v3_20221205_Poweo® Quick Up user manual
Emergency button
Battery label
Battery status
indicator