Table of Contents
Advertisement
It is recommended to have 2 batteries to replace the discharged battery with the charged
one. Therefore, Shado® will remain functional at all times.
Using the external charger
The external charger allows you to charge one battery while a second battery in being used.
To remove the battery from its compartment (device or wall charger):
1. Hold the handle with a hand facing up,
2. Close your hand while holding the handle,
3. Remove the battery by pulling towards you.
The handle top should be released from the bracket retaining lugs.
For installation, proceed with the reverse operations, taking care to verify
that the battery is properly inserted.
The green light is on when the wall charger is plugged in.
The orange light is on when the battery is being charged.
Maintenance of the battery
Never recharge batteries in extreme temperatures. If the temperature is too high, the
battery charger may stop functioning for security reasons. If this occurs, place the battery
and the charger in a cool place, wait a few minutes so the security device let the charge begin,
and try again to recharge the battery.
If you plan to not use your Shado
your batteries in good conditions:
•
Fully recharge your battery,
•
Push the emergency button to OFF position,
•
Remove the battery from its compartment,
•
Store your battery charged in a cool, dry, well ventilated area,
•
Check periodically (every month) the status of charge of the batteries: even if they are
disconnected batteries tend to discharge.
16
®
for a long time (≥ 1 month), proceed as follows to keep
DOMU019_EN_v16_20221206_Shado® shower trolleys user manual
Advertisement
Table of Contents
