NEC BladeServer Express5800 Series User Manual page 45

2-20 General Description
Power ON from CPU Blade
Press the POWER switch on the panel of the CPU blade (the POWER lamp on the CPU blade lights
green).
Power ON from Network Serial Port
Depending on the BIOS setting of the CPU blade, the CPU blade may be turned on by a packet
received from the network or via the modem connected to the serial port.
This power-on procedure can be specified by setting [Wake On Events] of [System Hardware] in the
BIOS SETUP Utility.
Operation after Power ON
If the CPU blade is connected to a display unit, the NEC logo appears on the screen of the display
unit after power-on.
While the NEC logo appears, the CPU blade runs the self-diagnosis program (POST). See "POST"
described later for details. At the completion of POST, the operating system is booted.
NOTE:
error message appears. See Chapter 8.
If a fault is found during POST, POST is interrupted and an
POWER lamp
POWER switch