NEC BladeServer Express5800 Series User Manual page 37

2-12 General Description
STATUS Lamp
The STATUS lamp lights green when the CPU blade is operating normally. When the STATUS
lamp is flashing amber or red, it indicates that the system has failed.
In addition, you can view detailed information on the error message on the virtual LCD when the
STATUS lamp is flashing amber or red.
You can use the virtual LCD through the Web browser of EXPRESSSCOPE engine (BMC) or NEC
DianaScope Manager.
The following tables list the indications of the STATUS lamp and virtual LCD, their descriptions,
and the actions to take.
If an error occurs, contact your service representative.
NOTE:
the System Event Log (SEL) to identify the cause of an error.
STATUS lamp
Status Color
On Green
Off –
On Red
Flash Red
Flash Amber
NOTE:
flashing amber or red, the indication of the STATUS lamp is retained.
When the CPU blade is powered on, the STATUS lamp lights green
(normal status).
If the CPU blade has NEC ESMPRO installed, you can view
STATUS lamp indications
Description
The CPU blade is operating
normally.
The power is turned off.
BMC is being initialized.
See the table "Virtual LCD indications when STATUS lamp is flashing red"
described later.
See the table "Virtual LCD indications when STATUS lamp is flashing
amber" described later.
If the CPU blade is powered off while the STATUS lamp is
Action
–
Turn on the power.
1. Wait until the lamp goes off.
2. If the lamp is still on, check installation
of the CPU blade.