NEC BladeServer Express5800 Series User Manual page 101

4-44 Configuring Your Server
Default settings and their explanation
Item
Battery Backup
Set Factory Defaults
Cluster Mode
Rebuild Rate
Patrol Read Rate
BGI Rate
CC Rate
Reconstruction Rate
Adapter BIOS
Coercion Mode
PDF Interval
Alarm Control
Cache Flush
Interval
Spinup Drive Count
Spinup Delay
StopOnError
*1 After performing Set Factory Defaults, change values of "Spinup Drive Count" and "Spinup
Delay" as shown in the table above, if they are not.
*2 Error notification by beep sound is not issued even if Alarm Control is set to Enabled.
Default Description
Present Displays Properties.
•
None When battery is installed: Present
•
When battery is not installed: None
No Restores factory defaults.
Yes
Disabled –
30 Recommended value: 30
30 Recommended value: 30
30 Recommended value: 30
30 Recommended value: 30
30 Recommended value: 30
Enabled –
Disabled
None –
128MB-way
1GB-way
300 –
Disabled Disabled: Does not issue an alarm.
Enabled
Silence
4 –
2 –
6 –
Disabled –
Enabled
Change
–
Permitted
Prohibited
Permitted
Permitted
Permitted
Permitted
Permitted
Prohibited
Prohibited
Prohibited
*2
Prohibited
Prohibited
*1
Prohibited
*1
Prohibited
Prohibited